Hi Forum,
ich habe das PiFace 2 in der config aktiviert und (ich denke) alle Treiber installiert.
Nach dem aufstecken und starten des Ras3 startet das Doorpi nicht mehr.
Ein manueller start ist auch nicht möglich.
Ein Test
bringt nur pifacedigitalio.core.NoPiFaceDigitalDetectedError: No PiFace Digital board detected (hardware_addr=0, bus=0, chip_select=0
ZitatVermutlich hast Du PiFace (Hardware und Software) installiert, aber SPI nicht aktiviert. Das kannst du entweder mit
sudo raspi-config-> 8 Advanced Options-> A5 SPI-> yes
ja auch das habe ich widerholt geprüft...
wenn ich das installiere sagt er mir das ich es ja schon auf dem neusten stand habe!
ZitatAlles anzeigenpi@raspberrypi:~ $ sudo apt-get install python-rpi.gpio
Reading package lists... Done
Building dependency tree
Reading state information... Done
python-rpi.gpio is already the newest version (0.6.3~stretch-1).
The following packages were automatically installed and are no longer required:
libpython-all-dev python-all python-all-dev python-keyring
python-keyrings.alt python-secretstorage python-wheel
Use 'sudo apt autoremove' to remove them.
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
pi@raspberrypi:~ $ sudo apt-get install python-pifacedigitalio
Reading package lists... Done
Building dependency tree
Reading state information... Done
python-pifacedigitalio is already the newest version (3.1.0-2).
The following packages were automatically installed and are no longer required:
libpython-all-dev python-all python-all-dev python-keyring
python-keyrings.alt python-secretstorage python-wheel
Use 'sudo apt autoremove' to remove them.
0 upgraded, 0 newly installed, 0 to remove and 0 not upgraded.
pi@raspberrypi:~ $
Das Trace gibt folgendes aus...
[ trace.txt ]
wenn ich folgendes schreib
Zitatpi@raspberrypi:~ $ sudo apt-cache search pifacedigitalio
dann zeigt er mir
Zitatpython-pifacedigitalio - API for PiFace Digital I/O boards (Python 2)
python-pifacedigitalio-doc - API for PiFace Digital I/O boards (common documentation)
python3-pifacedigitalio - API for PiFace Digital I/O boards (Python 3)
Wenn ich mal endlich das Face zum laufen bekommen würde!?
Das Face ist in der doorpi ini (orginalzustand) noch nicht eingetragen da die kiste ja nicht einmal starten will... und wenn ich die Datei über WinSCP bearbeite sagt er mir das ich keine berechtigung habe...
Oder muss es tatsächlich eingetragen werden um zu starten?
Dann würde aber ja der blink test funktionieren und er müsste doch was gefunden haben bzw anzeigen...
Grüsse Schweizer